Interactive-toy-concepts Triumph Bedienungsanleitung PDF herunterladen

The BladeRunner Triumph is a delicate machine, before removing it from the packaging please read the instructions!

PACKAGE CONTENTS:

Congratulations on the purchase of your BladeRunner Triumph helicopter. The BladeRunner Triumph brings advanced,

hobby-level flying technology to beginner, medium level or advanced flyers who are looking for great performance from

a relatively smaller helicopter. The BladeRunner Triumph has built-in advanced gyroscope technology for providing an

ultra-smooth flight and balance control assistance. The BladeRunner Triumph is available in 2 radio-control

frequencies: 27 MHz and 49 MHz. Do not throw away this instruction manual as it contains valuable information for

the operation of your helicopter as well as warranty information. The helpful tips in this pilot’s manual will improve your

skill and enhance your experience. Look for these symbols for extra help.

UNPACKING YOUR BLADERUNNER TRIUMPH HELICOPTER:

To prevent damage during shipping, the BladeRunner Triumph is securely fastened in the package. Please ensure

that all of the tie-down and fastening locations are unfastened before attempting to remove the BladeRunner Triumph

from the package. Be very careful when removing the BladeRunner Triumph to prevent damaging the helicopter.

ANTENNA

USB CHARGING CABLE

BALANCE BAR

TAIL ROTOR

REPLACEMENT TAIL ROTOR

REPLACEMENT CONNECTOR

CONNECTOR

TAIL MOTOR

TAIL BOOM

LANDING GEAR

RED LED LIGHT

PRO/NORMAL

SWITCH

LEFT STICK

UP / DOWN

THROTTLE

RIGHT STICK

Left/Right

Forward/Backward

2 USB

connectors

1 circular

charging plug

TRIM KNOB

ON / OFF SWITCH

POWER ON LED

Helicopter will not start,

LED on helicopter is off.

1. Helicopter not turned on.

2. Battery is not charged.

3. Helicopter was not set to off during

charging.

4. Rotors locked for overload

protection.

1. Turn helicopter on.

2. Charge internal helicopter battery.

3. Ensure helicopter is off and charge internal

helicopter battery.

4. Slide helicopter's on / off switch to off, then switch

on again.

Helicopter will not start,

LED on helicopter is ON.

1. Transmitter is not turned ON.

2. Radio link between the transmitter

and the helicopter is not initialized.

3. Helicopter’s battery is low.

1. Turn transmitter on.

2. Push left stick (UP/DOWN – throttle) completely to

UP, then back DOWN to initialize radio link.

3. Ensure helicopter is off and charge internal helicopter

battery.

Helicopter is flying too

high.

1. You need to reduce the throttle. 1. Move the left stick (UP/DOWN – throttle) gradually

down.

Helicopter is flying too low. 1. Needs more power/throttle.

2. The helicopter's battery is low.

1. Move the left stick (UP/DOWN – throttle) up.

2. Ensure the helicopter is off and charge the internal

helicopter battery.

Helicopter doesn’t hover. 1. The helicopter drifts

forward and backward.

1. Push the right stick (FORWARD/BACKWARD)

backward/forward to compensate and hold the

helicopter in position.

Helicopter doesn’t fly

backwards

1. The helicopter only flies backwards

briefly then spins to fly forward.

1. Aerodynamics make backward flights more difficult

than forward flight which is normal.

Practice flying backwards and control the left/right

turning motion of the helicopter to keep the tail

pointed in the direction you desire.

Helicopter doesn't move

forward fast enough.

1. The battery charge is getting low.

2. The tail rotor is damaged.

3. The helicopter center of gravity is

no longer correct.

1. Turn the helicopter off and charge the internal

helicopter battery.

2. Replace the tail rotor with new unit from the

replacement rotor kit (not included)

3. Use light adhesive tape to mount a clip on the front

bottom of the helicopter to add weight and adjust the

center of gravity. See also “Helicopter doesn’t hover”

issue.

Helicopter always turns. 1. Trim control is not set correctly.

2. The rotor blades have been

damaged/ or experience wear

of use.

1. Adjust the trim control knob. See “FIRST-FLIGHT

-TRIMMING YOUR HELICOPTER” section.

2. Replace the blades! It is hazardous to fly with

damaged blades!

The main rotors spin erratically

causing unpredictable flight

characteristics.

1. The balance bar to upper rotor

connector is either broken or

missing.

1. Install a new connector using the instructions in the

“REPLACING THE BALANCE BAR TO UPPER

ROTOR CONNECTOR” section.

CORRECTIVE ACTION:

CAUSE:

TROUBLESHOOTING

ISSUE:

There is a small connector which connects the upper rotor to the balance bar. If this connector is lost, broken, or

disconnected, a replacement is included with your Triumph. Follow the replacement steps listed below.

1. The connector is attached by 2 simple ball joints. Remove the broken connector by pulling it away from

the axle of the main rotors. Once removed, the 2 ball joints will be exposed.

2. Install the new connector following the reverse of step 1. Gently but firmly press the connector into position,

connecting the upper rotor and the balance bar. The connector will just snap into the 2 ball joints as shown.

Use only batteries recommended in this instruction manual. Do not mix old and new batteries. Do not mix alkaline, standard, lithium,

rechargeable, or different types of batteries. Do not use rechargeable batteries. Be careful to install the batteries with the correct polarity, as

indicated. Battery should be replaced by adults. Rechargeable batteries are only to be charged under adult supervision. Never leave a

battery unattended while it is being charged. Never leave a battery unattended in the presence of children. Non-rechargeable batteries are

not to be recharged. Rechargeable batteries are to be removed from the toy before being charged. Do not throw batteries into the fire.

Exhausted batteries are to be removed from the toy. The supply terminals are not to be short-circuited. The Triumph uses one 9-Volt (not

included).

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment. The manufacturer is not responsible for any radio or TV interference caused by unauthorized

modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. Note: This equipment has

been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These Limits are

designed to provide reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate

radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turn the equipment off and on, the user is encouraged to

try and correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna • Increase the

separation between the equipment and receiver • Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected • Consult the dealer or an experienced radio/TV technician for help.

Keep the BladeRunner Triumph helicopter away from face, eyes and hair at all times. Keep fingers away from moving rotors or propellers.

Do not fly the helicopter near or at other people or animals. Use caution when flying, make sure people around you know that you are

playing with the helicopter. Recommended for use outdoors and indoors. When flying outdoors avoid operating your BladeRunner Triumph

helicopter near power-lines, trees, or roof-tops. Do not fly your BladeRunner Triumph helicopter during windy conditions, rain or any other

form of precipitation or harsh weather. Also make sure that your BladeRunner Triumph helicopter does not have the opportunity to land in a

wet or hazardous area such as snow, water, mud, or rocks. When flying indoors, only fly in rooms without obstacles, breakable objects or

fans. The USB charging cable provided in this package is for charging the helicopter ONLY. Do not use any other source to charge the

helicopter. Do not attempt to overcharge your helicopter. Follow the charging instructions provided in this instruction manual.

REPLACING THE BALANCE BAR TO UPPER ROTOR CONNECTOR:

IMPORTANT SAFETY INFORMATION

IMPORTANT BATTERY INFORMATION

FCC NOTE: U.S. ONLY

Lithium Polymer Rechargeable

Batteries must be recycled or

disposed of properly.

Required (not included) One 9V alkaline battery (transmitter).

ON/OFF SWITCH

PLEASE! DO NOT RETURN THIS PRODUCT TO ANY RETAIL STORE!

For any questions or problems with this product please contact us at:Email: info@interactivetoy.com

Phone: Inside North America: +1-416-444-6873 Outside North America: 1-866-214-2220

Address: Interactive Toy Concepts, 17 Vulcan Street, Toronto, Ontario, Canada. M9W 1L3

Limited 30-day warranty

Product is warranted by Interactive Toy Concepts Limited against manufacturing defects in material

and workmanship under normal use for thirty (30) days from the date of purchase.

Warranty is validated upon receipt of proof or purchase and confirmation of UPC code.

Proof of Purchase

This radiocommunication device complies with all the requirements and limits of Industry Canada Standard RSS-310.

Operation is subject to the following two conditions: 1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause undesired operation. Field Strength

and measurement distance: 27.145MHz – 61.35 dBµV/m at 3 meter. 49.860MHz - 59.69 dBµV/m at 3 meter.

Industry Canada Notice: Canada only.

1. 1 x BladeRunner Triumph Helicopter

2. 1 x USB charging cable

3. 1 x Radio Controller & 1 x Antenna

4. 1 x Replacement Tail Rotor

5. 2 x Replacement Balance Bar to

Upper Rotor Connectors

UPPER ROTOR

LOWER ROTOR

INS-50418-130601-US

Manufactured by and distributed by Interactive Toy Concepts Ltd. Conforms to Safety Standards ASTM F963

Meets CPSC Safety Requirements.

Regulatory Requirements. Products and colors may vary. MADE IN CHINA.

Warning: Spinning propellers can cause injury to people, animals and plants as well as damage to furniture and other

property. To avoid the risk of injury or damage, stay clear of spinning propellers. Always keep a minimum distance of

about 80 inches (2 meters) between the spinning propellers and people, pets, or other objects.

Spinning propellers may cause severe injury to eyes, potentially causing blindness if they contact the eyes. Do not fly the Triumph helicopter near

or towards the face. Especially do not fly the Triumph helicopter near or towards the eyes. Interactive Toy Concepts Ltd. will not accept liability for

misuse of the Triumph helicopter causing any bodily injury, including, but not limited to eye injury.

Spinning propellers may cause extensive and possibly irreparable damage to television sets, light fixtures, and other furniture and accessories

commonly found at home and in other indoor locations. Do not fly the Triumph helicopter indoors. Especially do not fly the Triumph helicopter near

or towards any television sets, light fixtures, or any other furniture or household accessories. Interactive Toy Concepts Ltd. will not accept liability for

misuse of the Triumph helicopter causing any damage to television sets, light fixtures or any other furniture or household accessories.

IMPORTANT WARNINGS!

1 2

Inhaltsverzeichnis

Seite 1 - IMPORTANT WARNINGS!

The BladeRunner Triumph is a delicate machine, before removing it from the packaging please read the instructions! 12PACKAGE CONTENTS:5.Congratulation

Seite 2

ATTENTION:Check the condition of all the rotor blades prior to each flight. Do not try to operate the Interceptor helicopter if any rotor blade has be

Verwandte Modelle: Interceptor R | Interceptor C |

Kommentare zu diesen Handbüchern

Keine Kommentare

Interactive-toy-concepts Triumph Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Spielzeuge Interactive-toy-concepts Triumph herunter. Interactive Toy Concepts Triumph User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: Interceptor R | Interceptor C |

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Spielzeuge Interactive-toy-concepts Triumph